Xlt XD-9010B Manual de usuario descargar pdf (Pagina 74)

Hood Installation

Lifting Jack Setup

Each lifting jack consists of three (3) parts; the pole/winch assembly, extension tube, and tripod

base.

 Check for smooth operation. The cable should not be pinched and should pass

smoothly over the pulley on top of the pole assembly.

 Inspect cable prior to each use.

 If cable is frayed or shows signs of excessive wear and tear, DO NO USE until

cable is replaced.

 At a minimum replace the cable annually with wire rope that meets or exceeds

the jack manufacturer’s specifications.

 Do not exceed the stated capacity of the jack.

WARNING

1. Place the smaller end of extension tube into tripod base.

2. Place bottom of the pole into the top of the extension tube and tighten knob.

Pole/Winch Assembly

Extension Tube

Tripod Base

Back of Hood

Bottom of Hood

Cart

Lifting Gear

Illustrations shown with AVI hood on cart, same instructions apply when hood is crate shipped.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 105 106

Sin comentarios

Xlt XD-9010B Manual de usuario Pagina 74